I believe only the 2014 model has this...

Bill

 

correct again !!!

 

Thanks for the info. Even further limits my chances. But do gladly appreciate it.

 

Wrecking yard websites might be your best hope.

 

Never heard of this....got a photo of this cup holder/cushion?

 

Chevy SS Forum - View Single Post - Rear Cup Holders

 

If anyone in MD, DE, NJ, northern to central VA, northern WV, or the eastern half of PA has a 2014 and is willing to give up their cupholder seat bottom, I will meet you, pay you, and give you my 2017 bottom cushion as part of the deal. Looks like there are only a couple of wrecking yards in the country that have this part, and the ones they have are in bad condition and quite expensive.

 

The cup holder is available separately, I wonder if the foam and cover could be cut to allow it's install. I have a 14 and a 15. If I have time tomorrow I'll pull buy customs and see if the cup holder could be retro fitted.

 

I believe it’s been tried on the G8. Didn’t work.

 

I’m just curious what you get with these over the cup holders that fold down from the rear seat back (besides opening the car up to everything in your trunk) ... what would make this worth the effort to someone?

 

One, not having to have your trunk open, and two, the ability to open the cupholders without getting out of the car and putting the pass-through down. Also, they are ever so slightly closer to the front seat than the pass-through cupholders, which is nice for those of us with manual transmissions who can't really use the left front cupholder.

 

Try EBay I'm not sure about seperatly but I've seen a few sets on there. Good luck.

 

I used one of these in my E39 M5 (which had far worse cupholders) and it worked well. I don't know if it would work with the SS, but may be worth looking into.




BMW Cup Holders, Porsche Cup Holders, Ultimate Cup Holder - Cupholders / Drink Holders for BMW 3 5 7 Series, Boxster 911 Z4 Mercedes Audi NSX other fine cars.

 

Its still insane to me that the SS people decided to remove this...

 

Certainly seems like the original cupholder in the seat cushion was more usable. But as they say, sometimes it's a matter of "continual product improvement". I actually take that to mean (in this case) that it was much more expensive to produce -or- they were getting a lot of warranty repair costs. Like if people were sliding across to the center of the seat without realizing the cupholder was open.