Chevy SS Forum banner
1 - 20 of 48 Posts

· Registered
Joined
·
657 Posts
Discussion Starter · #1 ·

· Premium Member
Joined
·
2,962 Posts
And they will waive the shipping on the 2nd row when they become available.
 

· Registered
Joined
·
657 Posts
Discussion Starter · #5 ·
  • Like
Reactions: KenzSS and Tarnath

· Premium Member
Joined
·
7,509 Posts
Anybody get theirs yet?
 

· Registered
Joined
·
657 Posts
Discussion Starter · #8 ·
Anybody get theirs yet?
A guy on the Chevy SS Facebook group got his already. He also installed G8 rear mats and they are a near perfect fit.
 

· Registered
Joined
·
738 Posts
So I picked up mine today from the factory as Bolingbrook is only about 40 miles from my house. While there today, the nice lady at the counter verified both the rear mats and a custom fit trunk liner are on its way for the car. They were surprised how many people have bought the front liners already. Its great to hear they will make a custom rear trunk liner. I go long range rifle shooting a lot during the summer and my steel targets tend to tear up the trunk carpeting. Good news for sure.
 

· Super Moderator
Joined
·
9,765 Posts
Good to hear Headrat, ordered mine last night.
 

· Registered
Joined
·
738 Posts
I have to admit, these are very nice. Never bought anything from them before, but these are top notch. i also love how they include 2 sets of velcro grommets that fit around the stock pegs and hold their mats in place. Very nice engineering.
 

· Super Moderator
Joined
·
9,765 Posts
I had a set of rugged ridge liners in the truck, very nice but with a design flaw. The emblem in the middle wasn't glued to the top of the liner but had pins going through to the backside with those round, uh, press barb thingies holding it on. Moisture got through and put little rust spots on the Callaway SC540 mats. Got 'em clean, but seemed to defeat the purpose...Looking forward to the Weathertechs.
 
1 - 20 of 48 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top