MAP sensor on 102 intake

440 Views 4 Replies 3 Participants Last post by Nealy, 2 mo ago

Nealy

Discussion Starter · 2 mo ago

Sooooo I’m putting in the 102 intake on my 17. Well I’ve run into a dozen different problems… but the one that has me needing help the most is, the 102’s MAP sensor is on the top where as the stock is on the left side. The wires are long enough for the stock sensor but now that I have the 102, the wires DO NOT reach. Is there a wire harness to extend it or do I dare untie the bundle that it’s connected to and see if there’s any slack? Please help.

Save

1 - 5 of 5 Posts

SS WOT

· #2 · 2 mo ago

Summit has a couple choices...

https://www.summitracing.com/search/part-type/map-sensor-extension-harnesses/make/chevrolet/engine-size/6-2l-376/engine-family/chevy-small-block-gen-iii-iv-ls-based-engines

Nealy said:
Sooooo I’m putting in the 102 intake on my 17. Well I’ve run into a dozen different problems… but the one that has me needing help the most is, the 102’s MAP sensor is on the top where as the stock is on the left side. The wires are long enough for the stock sensor but now that I have the 102, the wires DO NOT reach. Is there a wire harness to extend it or do I dare untie the bundle that it’s connected to and see if there’s any slack? Please help.

Save

Reactions: 1

Nealy

Discussion Starter · #3 · 2 mo ago

I searched the sight but I was blind obviously. Thank you so much. Wish I would have known this before I got my other parts in today. 😂

Save

TheMealOnWheels

· #4 · 2 mo ago

If I recall correctly, I was able to just undo the wire loom a few inches back, sneak it under the fuel rail and connect it with a little slack. I bet you've already ordered, but it's not required.

Save

Nealy

Discussion Starter · #5 · 2 mo ago

Glad there’s another way. Gonna have my mechanic buddy check it out Saturday. I’m too afraid to mess with wires haha

Save

1 - 5 of 5 Posts

Top Contributors this Month