Chevy SS Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
2,752 Posts
Discussion Starter · #1 ·
I am getting ready for swapping factory bulbs for white LEDs, did not notice any write ups on these so I went into the car for an hour and have a few four letter words for whoever designed the system.

In all the cars I've had (Nissan, Acura, Hyundai), the lights were under light plastic, no big deal.

In this car, the entire assembly needs to come out HALF THE TIME!

Anyway, I've figured out how to swap Visors (2 bulbs per), Front Lights (3 bulbs), Rear Lights (3 bulbs), Trunk (10w), Glove compartment (1 bulb) and was very surprised the doors did not have a puddle light or don't run me over when I open the door light. I have never had a car that did not have those lights...

Either way, if there is enough interest I will document every step and post up pictures. If someone already did it before me, would like to see which bulbs you went with.

037
 

· Registered
Joined
·
657 Posts
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top