Chevy SS Forum banner

Dyno results of Roto-Fab and livernois tune.

5691 Views 13 Replies 8 Participants Last post by  DoctorWho
Today I put my car on the dyno at LG motor sports in the DFW area. Temp was about 55F with over 80% humidity. I've had the roto-fab CAI and livernois tune for about 2 weeks now. Before you ask I don't have a dyno run before the update so bear with me. Typically LGs dynojet reads a little low compared to what I see at others. For reference they see about 320 whp for A6 L99 camaros and about 350 whp for A6 LS3 vettes. So I figure our cars should be around 330 whp to 335 whp on their setup. I put down a best run of 367 whp and 366 tq. Average of three pulls was 363whp and 361 tq. All in all very good for a CAI and a tune!!! I hope this helps those looking for third party independent testing :).
  • Like
Reactions: 3
1 - 2 of 14 Posts
300ft lbs by 2300 rpm!! I need a V8!

Yeah, that's what I'm missing with my 380HP 4cy turbo. My 300ft lbs shows up around 4k (but then 380 all the way to 7k).
What are you driving... an STI?
A modified Legacy Spec-B. Basically a more grown up STI without dual AVCS.
1 - 2 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.